Filter
Top Products
Chapter 8 Maintenance and Troubleshooting
126
8-4 Alarms
MAX# SB CLP on, limit, off An attempt was made to add a sub clip
when the number of registered sub clips
had already reached the upper limit
(300) of the specifications of this unit.
These operations are not possible.
CL OVER DUR on, limit, off An attempt was made to add a sub clip
when the total duration of sub clips in the
clip list had already reached the upper
limit (24 hours) of the specifications of
this unit.
Run Salvage on, limit, off An attempt was made to record, display
an E-E picture, record an essence mark,
or add a quick scene selection sub clip
on a disc which requires clip recovery
(salvage).
Try the operation again after executing the
salvage function.
For details, see 3-6-7 “Handling of Discs
When Recording Does Not End Normally
(Salvage Function)” (page 40).
CNT mode! on A time code or user bits preset operation
was attempted with “COUNTER”
selected by the COUNTER SEL button.
Try the operation again after selecting “TC”
or “UB” with the COUNTER SEL button.
TC EXT! on A time code or user bits preset operation
was attempted with the INT/EXT/RP188
switch is set to EXT and the PRESET/
REGEN switch is set to PRESET.
Try the operation again after setting the
INT/EXT/RP188 switch to INT and the
PRESET/REGEN switch to PRESET.
See 7-3-2 “Extended Menu Operations”
(page 108) about how to make this setting.
REGEN mode! on A time code or user bits preset operation
was attempted with the PRESET/
REGEN switch is set to REGEN.
REC-PAUSE! on A time code or user bits preset operation
was attempted with recording paused.
Try the operation again after stopping
recording.
REC mode! on, limit An attempt was made to switch video or
audio signals during recording.
REC mode! on, limit, off An attempt was made to display the
system menu “DISC MENU” during
recording.
REC mode! on, limit The THUMBNAIL button was pressed
during recording.
REC mode! on, limit, off An attempt was made to display DRIVE
MAINTENANCE in the maintenance
menu during recording.
No SEL List on, limit The SUBCLIP button was pressed
without loading a clip list from the disc
into the current clip list.
Try the operation again after loading a clip
list.
For details, see 5-3-1 “Loading a Clip List
From Disc Into Unit Memory” (page 68).
No SUB Clip on, limit A button in the playback control section
was pressed when there were no sub
clips in the current clip list.
Playback is not possible without a sub clip
in the current clip list.
SB CLP mode on, limit The SHIFT button and the THUMBNAIL
button were pressed together with the
SUBCLIP button lit.
Press the SUBCLIP button, turning it off,
and try the operation again.
SUB CLIP NG on, limit The SHIFT and SET buttons were
pressed together when IN and OUT
points were not set correctly (the OUT
point was set before the IN point, etc.).
Set the IN and OUT points correctly and try
the operation again.
No List! on, limit, off An attempt was made to delete a clip list
with no clip lists saved on the disc.
This operation is not possible.
Message in time
data display
Display
condition
a)
Description Action