Filter
Top Products
Chapter 2 Names and Functions of Parts
21
2-4 Connectors
2-4 Connectors
a PHONES jack and LEVEL knob
The jack is a standard stereo jack. Connect stereo
headphones with an impedance of 8 ohms, to monitor the
audio during playback. (Non-audio signals are muted.)
The channels monitored are selected by the AUDIO
MONITOR SEL button.
Adjust the volume with the LEVEL knob. When extended
menu item 820 “AUDIO OUTPUT CH1/CH2 SELECT”
is set to “moni,” you can also cause this to simultaneously
adjust the output volume from the AUDIO OUT 1/3 and 2/
4 connectors on the side panel. To do this, in the setup
menu, set extended menu item 114 “AUDIO MONITOR
OUTPUT LEVEL” to “var.”
When no headphones are connected, you can listen to
audio through the built-in speaker (monaural).
b DC OUT (DC power output) 12V connector (4-pin,
female)
Supplies power to the BVR-3 Remote Control Unit (not
supplied) and the RM-280 Editing Controller (not
supplied). (Max. 5 W)
Note
Do not connect to any external device except those listed
above.
PHONES
REF VIDEO INREMOTE DIGITAL AUDIO (AES/EBU)
AC IN
DC IN
12V
S400
IN
DC OUT 12V
1/2 3/4 OUT 1/2 3/4
SDI
IN OUT(SUPER)
VIDEO
IN OUT1 OUT2(SUPER)
TC
IN OUT
AUDIO OUT
1/3 2/4
1/3 2/4
AUDIO IN
1 PHONES jack and LEVEL knob
2 DC OUT 12V connector
3 REMOTE connector
4 REF VIDEO IN connector
2Analog audio signal inputs/
outputs (see page 23)
3 Analog video signal inputs/outputs (see page 23)
4 SDI signal inputs/outputs (see page 23)
5 (network) connector
6Power supply
section (see
page 24)
5Time code inputs/outputs
(see page 24)
Front
Right side
1Digital audio signal
inputs/outputs (see page
6 S400 (i.LINK) connector