Filter
Top Products
Chapter 7 Menus
109
7-3 Extended Menu
3
Replace the cover.
Note
Tighten the screws firmly.
To enable extended menu display in the
maintenance menu
The menu screens in the following procedure are those that
appear in the video panel, and on a monitor to which the
output of the VIDEO OUT 2 (SUPER)/SDI OUT
(SUPER) connector is input.
Proceed as follows.
1
Press the MENU button.
The setup menu appears in the video panel and on the
external monitor.
2
Hold down the COUNTER SEL button, and press the
SET button.
The screen switches to the maintenance menu.
3
Use the F/f buttons to select “SETUP
MAINTENANCE.”
4
Press the g button.
5
Use the F/f buttons to select “EXTENDED MENU.”
6
Press the g button.
7
Press the f button to select “ENABLE.”
8
Press the SET button.
When you next display the menu and change the item
display, the extended menu will appear after the basic
menu.
7-3-3 Using UMID Data
To perform operations from interviewing to editing
effectively and to detect audio-visual materials easily
when reusing them, metadata that provides additional
information is recorded along with audio-visual data. As
one of application of metadata, the UMID (Unique
Material Identifier) is internationally standardized.
12341234
12341234
Set this switch to “ON.”
ACCESS
SHUTTLE JOG
THUMB
NAIL
ESSENCE
MARK
MENU
S.SEL
SET
RESET
SHIFT
TOP F REV
ALL/CH-1 CH-2 CH-3 CH-4
TC
F FWD
AUDI O
END
REC
PRESET
VARIABLE
PB
PREV NEXTPLAY STOP REC
CLIP
MENU
SYSTEM
MENU
MONITOR
SEL
METER
SEL
HOLD
COUNTER
SEL
SUB
CLIP
MARK1
MARK2
IN
OUT
KEY INHI
ON
OFF
NETWORK
LOCAL
REMOTE
F-RUN
R-RUN
PRESET
REGEN
INT
EXT
RP188
L/ST/R
4,63,5,7
128
ADJUST
DRIVE MAINTENANCE
MAINTENANCE MENU
BATTERY CONFIG
AUDIO CONFIG
CHECK
NETWORK CONFIG
SETUP MAINTENANCE
t
SERVICE SUPPORT
OTHERS
EXTENDED MENU : dis
SETUP MAINTENANCE
MAINTENANCE MENU
SAVE MENU DATA
LOAD MENU DATA
SETUP BANK4
AU BANK RECALL: off
RESET ALL SETUP
T t
EXTENDED MENU : dis
SETUP MAINTENANCE
MAINTENANCE MENU
ENABLE
* DISABLE
T