Filter
Top Products
Chapter 7 Menus
108
7-3 Extended Menu
7-3-2 Extended Menu Operations
The extended menu can be used with the same procedures
as in the basic menu.
However, since with the factory default settings the
extended menu is not displayed, it is first necessary to
enable display of the extended menu.
See “Basic setup menu operations” (page 94) for more
information about how to select menu items and how to
change their values.
Enabling display of the extended menu
To enable display of the extended menu, an internal switch
must be set to on, and extended menu display must be
enabled in the maintenance menu. (The internal switch is
set to on when the unit is shipped from the factory. Unless
you have set it to off, there is no need to change the switch
setting.)
To set the internal switch to on
1
Using a Phillips screwdriver, remove the cover on the
rear panel of this unit
2
Use a ballpoint pen or other sharp implement to set the
leftmost of the DIP switches on the right side to the
ON (top) position.
Note
Do not use a pencil for this operation, as graphite
deposits can cause short circuits and lead to failure.
838 AUDIO MONITOR CHANNEL
ARRANGE
Together with item 837, select the audio signals (tracks 5 to 8) to assign
to the left and right channels of the audio monitor.
Sub-item
L-5 Lch/tr5 No display: Do not assign.
on: Assign.
The factory default settings are as follows.
Lch: No display
Rch: No display
L-6 Lch/tr6
L-7 Lch/tr7
L-8 Lch/tr8
R-5 Rch/tr5
R-6 Rch/tr6
R-7 Rch/tr7
R-8 Rch/tr8
Menu items in the 800s, relating to audio control
Item number Item name Settings
Menu items in the 900s, relating to digital process
Item number Item name Settings
920 SD-SDI H-ANC CONTROL Select whether or not to add information to the SDI output.
Sub-item
1 AUDIO 5CH-8CH off: Do not add digital audio data channels 5 to 8.
on
: Add digital audio data channels 5 to 8.
2 RP188 ATC off: Do not add RP188 time code data.
on
: Add RP188 time code data.