Filter
Top Products
Chapter 3 Preparations
33
3-2 Power Preparations
3-2 Power Preparations
This unit can be powered by a battery pack, DC power, or
AC power.
3-2-1 Using AC Power
Connect an AC power source (100 V to 240 V AC, 50/60
Hz) to the ~ AC IN connector on the right side of the unit
with an AC power cord (not supplied, see page 133).
3-2-2 Using DC Power
Connect a DC power source to the DC IN 12V connector
on the right side of the unit.
3-2-3 Using a Battery Pack
Usable battery packs
The battery packs usable with this unit are as follows.
BP-GL95, BP-GL65, BP-L80S, BP-L60S
To attach a battery pack
Proceed as follows.
1
Remove the cover of the battery pack shoe.
2
Fit the battery pack.
To remove the battery pack
Follow the above procedure in the reverse flow. After the
battery pack is removed, replace the cover of the battery
pack shoe.
When several power sources are
connected
The following table shows the automatically selected
power source that drives this unit.
a) Switches to DC power immediately if AC power supply is interrupted.
b) Switches to battery pack power immediately if AC power supply is
interrupted.
c) Does not switch to battery pack power, even if DC power supply is
interrupted. To drive this unit from the battery pack, disconnect the DC
power connector from the DC IN 12V connector.
SDI
2
1
SDI
Power types Power that
drives this
unit
AC power DC power Battery pack
Connected Connected Mounted
AC power
a)
Connected Connected –
AC power
a)
Connected – Mounted
AC power
b)
– Connected Mounted
DC power
c)