Filter
Top Products
88
Troubleshooting (continued)
Symptom Cause and countermeasure
The sound skips.
Play does not start
from the first
track.
“—OVER—” is
displayed.
A CD button
lights even though
there is no CD
loaded.
Tuner (Radio)
Symptom Cause and countermeasure
Severe hum or
noise/stations
cannot be
received.
The disc you tried to play is a non-standard size or shape, or uses a non-standard
recording method.
m Replace the disc.
The system is subject to vibration.
m Try moving the system to a place without vibration (e.g., on top of a stable
stand).
m Try moving the speakers away from the system, or placing them on separate
stands.
When you listen to a track with bass sounds at high volume, the speaker
vibration may cause the sound to skip.
The CD player is in Program or Shuffle Play mode.
m Press PLAY MODE repeatedly until “PROGRAM” or “SHUFFLE” disappears
to return to normal play.
You have reached the end of the disc while pressing ).
m Keep pressing 0 or turn MULTI JOG to return to the desired playing
position.
The first time that you turn the system on after purchase, the buttons light for a
short moment, and then turn off.
The last time that you used the unit, you pressed 1/u (power) and turned the
system off while the CD tray was open.
m If you wait for a moment, the light will turn off. If not, press CD1–56 to
open and close the trays.
The broadcast station band (FM and AM for the North American model, FM, MW
and LW for the European model, FM, MW and SW for other models) or frequency
are not correct.
m Set the proper band and frequency (see page 10).
The antenna is not connected properly.
m Connect the antenna properly (see pages 6 and 7).
• The antenna is set up in a place with poor reception.
• The signal strength is too weak.
m Find a place and an orientation that provide good reception, then set up the
antenna again.
If you cannot obtain good reception, we recommend you connect a
commercially available outdoor antenna.