Polycom SIP 3.1 Speaker System User Manual


 
Administrator’s Guide SoundPoint IP / SoundStation IP
3 - 16
2. (Optional) Create new configuration file(s) in the style of sip.cfg by
performing the following steps:
For more information, especially on the SIP server address, refer to SIP
<SIP/> on page A-10.
For more information on the sip.cfg file, refer to Application
Configuration on page A-4.
Most of the default settings are typically adequate, however, if SNTP
settings are not available through DHCP, the SNTP GMT offset and
(possibly) the SNTP server address will need to be edited for the correct
local conditions. Changing the default daylight savings parameters will
likely be necessary outside of North American locations.
a (Optional) Disable the local web (HTTP) server or change its
signalling port if local security policy dictates.
b Change the default location settings for user interface language and
time and date format.
3. (Optional) Create a master configuration file by performing the following
steps:
a Create per-phone or per-platform <Ethernet address>.cfg files by
using the 00000000000.cfg and files from the distribution as templates.
For more information, refer to Master Configuration Files on page
A-2.
b Edit the CONFIG_FILES attribute of the <Ethernet address>.cfg files
so that it references the appropriate phone[MACaddress].cfg file.
For example, replace the reference to phone1.cfg with
phone[MACaddress].cfg.
Note
For more information on why to create another configuration file, refer to the
“Configuration File Management on SoundPoint IP Phones” whitepaper at
www.polycom.com/support/voice/ .