Polycom SIP 3.1 Speaker System User Manual


 
Configuration Files
A - 91
This configuration attribute is defined as follows:
Request <request/>
This attribute includes:
Delay <delay/>
Delay <delay/>
These settings control the phone’s behavior when a request for restart or
reconfiguration is received.
Attribute
Permitted
Values Default Interpretation
ramdisk.enable 0, 1 1 If set to 1, RAM disk will be available. The RAM
disk is used to cache downloaded wave files, and
other resources for the user interface.
ramdisk.bytesPerBlock 0, 32, 33, ...,
1024
0 These four parameters use internal defaults when
value is set to 0.
Note: For the SoundPoint IP 650 platform,
ramdisk.bytesPerBlock is internally replaced by 2X
the value.
Note: For the SoundPoint IP 7000 platform,
ramdisk.bytesPerBlock is internally replaced by 4X
the value.
ramdisk.blocksPerTrack 0, 1, 2, ...,
65536
0
ramdisk.nBlocks 0, 1, 2, ...,
65536
4096
ramdisk.nBlocks.IP_650 0, 1, 2, ...,
65536
2048
ramdisk.minsize 50 to 16384 50 Smallest size in Kbytes of RAM disk to create
before returning an error. RAM disk size is variable
depending on the amount of device memory.
ramdisk.minfree 512 to 16384 3072 Minimum amount of free space that must be left
after the RAM disk has been created. The RAM
disk’s size will be reduced as necessary in order to
leave this amount of free RAM.
Attribute
Permitted
Values
Default Interpretation
request.delay.type Null, “audio”, or
“call”
call Defines the strategy to adopt before a request gets
executed. If set to “audio”, a request can be executed as
soon as there is no active audio on the phone,
independently of any call state. If set to “call”, a request
can be executed as soon as there are no calls in any
state on the phone.