Polycom SIP 3.1 Speaker System User Manual


 
Configuring Your System
4 - 63
e Locate the
voIpProt
parameter.
Set the
voIpProt.server.x.transport
attribute to TCPpreferred or
TLS.
Your selection depends on the LCS configuration.
f Set the
voIpProt.server.x.address
to the LCS address.
For example,
voIpProt.server.1.address = "lcs2005.local"
g Set the
voIpProt.SIP.lcs
attribute to 1.
h (Optional) If SIP forking is desired, set
voIpProt.SIP.ms-forking
attribute to 1.
Refer to SIP <SIP/> on page A-10.
i Save the modified sip.cfg configuration file.
2. Modify the phone1.cfg configuration file as follows:
a Open phone1.cfg in an XML editor.
b Locate the registration parameter.
c Set the
reg.1.address
to the LCS address.
For example,
reg.1.address = "7778"
d Set the
reg.1.server.y.address
to the LCS server name.
e (Optional) Set the
reg.1.server.y.transport
attribute to
TCPpreferred or TLS.
Your selection depends on the LCS configuration.
f Set
reg.1.auth.userId
to the phone's LCS username.
For example,
reg.1.auth.userId = "jbloggs"
g Set
reg.1.auth.password
to the LCS password.
For example,
reg.1.auth.password = "Password2"
h Locate the
roaming_buddies
attribute.
i Set the
roaming_buddies.reg
element to 1.
Refer to Roaming Buddies <roaming_buddies/> on page A-122.
j Locate the
roaming_privacy
attribute.
k Set the
roaming_privacy.reg
element to 1.
Refer to Roaming Privacy <roaming_privacy/> on page A-123.
l Save the modified phone1.cfg configuration file.
Note
The TLS protocol is not supported on SoundPoint IP 300 and 500 phones.