Filter
Top Products
Advanced Operation
99
Other function
Playing Super Audio CDs with an IEEE1394
cable
1
Select the input source to which IEEE1394 was
assigned at the “IEEE1394 Assign” ( page
107) in the system setup.
Example: CD
(Main unit) (Remote control unit)
• The IEEE1394 indicator lights.
Lights
2
Select the surround mode.
Example: DIRECT
(Main unit) (Remote control unit)
3
Start playback on the selected component.
• The DSD indicator lights.
Lights
For operating instructions, refer to the component’s
manual.
“DSD DIRECT” is shown on the display when playing
DSD 2 channel signals in the DIRECT mode. “DSD
MULTI DIRECT” is displayed when playing DSD multi-
channel signals in the DIRECT mode (SB CH OUT
“OFF”).
When playing DSD signals in the DIRECT or PURE DIRECT
mode, the DSD signals are converted into analog signals.
When playing in other surround modes, the DSD signals are
first converted into PCM signals. The input signal and
playing status can be checked by pressing the ON SCREEN
button on the remote control unit.
Example: When DSD multi-channel signals are played in
the DIRECT mode
Example: When DSD multi-channel signals are played in
the 9CH STEREO mode
FUNCTION
DIRECT/STEREO
ON SCREEN
DIRECT/STEREO
FUNCTION
AMP