Filter
Top Products
82
Advanced Operation
1
Press the MODE SELECTOR button for the
device to be set in the preset memory.
Presetting is not possible for the AMP, ZONE2,
ZONE3, ZONE4, TUNER and SYSTEM CALL modes.
2
Press and hold the RC SETUP button for at
least 3 seconds.
• The IR segment blinks twice and the input mode is
set.
• There may be several preset codes for some brands. If the
remote control unit does not work properly with one code,
try inputting another code.
• Buttons that have been learned have priority over the signals
set with the preset memory function. If a learned button
setting is not needed, please erase it ( page 86).
Setting the preset memory function
• The various devices can be operated by setting the preset
memory on the attached remote control unit.
For some models the remote control unit or the device may
not operate properly. In this case, use the learning function
( page 84) to store your device’s remote control signals
in the attached remote control unit.
3
Input the (5-digit) number for the brand of the
device to be set in the preset memory, as shown
on the list of preset codes ( End of this
manual).
• The IR segment blinks twice when the memory is
set.
• When a preset code is transmitted, the mode
indicator for the device to which that code belongs
blinks.
The input mode is canceled if no operation is
performed for 10 seconds.
1
Press the MODE SELECTOR button for the
device to be operated.
• The indicator of the device to be operated blinks.
2
Operate the component.
For details, refer to the component’s operating
instructions.
Operating a component stored in the
preset memory
MODE SELECTOR
RC SETUP
IR segment
NUMBER
0 ~ 9, +10
TV/VCR
SFT
MENU
SRCH
BAND, MODE, MEMO
SOURCE (SRC) OFF
SOURCE (SRC) ON
ENTER
SETUP
DISP
CH
+, –
A ~ G
,
ª
,
•
1
,
8
9
,
6
7
,
3
,
2
D
H
F
G
EL Display
Buttons