Filter
Top Products
119
Advanced Setup – Part 1
Press the CURSOR
DD
or
HH
button to select
“Exit”, then press the
ENTER button.
• The “System Setup Menu” reappears.
7
• “Base Curve Copy” is displayed after performing the Auto
Setup.
•To restore the settings to their defaults, select “Default Yes
0
”, then press the CURSOR
FF
button.
1
Press the CURSOR
DD
button to select “Base
Curve Copy”, then press the
CURSOR
FF
button.
• Switch to the “Base Curve Copy” screen.
2
Press the CURSOR
FF
button to select “Yes”.
3
Press the ENTER button to enter the setting.
• The “Manual EQ” screen reappears.
The type of the copied correction curve is displayed in
the upper right of this screen.
• If the “Auto Setup” procedure has not been performed, this
item is not displayed.
2
Procedure for copying the “Flat” correction curve