Filter
Top Products
46
Basic Operation
Press the ON SCREEN button.
Each time an operation is performed, a description of
that operation appears on the display connected to AVR-
5805CI’s VIDEO MONITOR OUT terminal. Also, the
unit’s operating status can be checked during playback.
Such information as the position of the input selector
and the surround settings is output in sequence.
Checking the currently playing program
source, etc.
2 On screen display
Press the DIMMER button.
The display brightness changes in four steps (bright,
medium, dim and off).
2 Using the dimmer function
• Use this to change the brightness of the display.
Press the STATUS button.
Descriptions of the unit’s operations are also displayed
on the front panel display. In addition, the display can be
switched to check the unit’s operating status while
playing a source.
2 Front panel display
ANALOG SURROUND PARAMETER
INPUT MODE
STATUS
DIMMER
EXT. IN
CURSOR
INPUT MODE
ON SCREEN
SURROUND
PARAMETER
CURSOR
Press the INPUT MODE button.
The mode switches as shown below each time the
INPUT MODE button on the main unit is pressed:
2 Selecting the AUTO, PCM and DTS modes
AUTO PCM DTS
AUTO
EXT.IN -1EXT.IN -2 ANALOG
PCM DTS
The mode switches as shown below each time the
INPUT MODE button on the remote control unit is
pressed:
(Remote control unit)
When operating the remote control unit:
AUTO (All auto mode):
In this mode, the types of signals being input to the
digital and analog input terminals for the selected input
source are detected and the program in the AVR-
5805CI’s surround decoder is selected automatically
upon playback. This mode can be selected for all input
sources other than PHONO and TUNER.
The presence or absence of digital signals is detected,
the signals input to the digital input terminals are
identified and decoding and playback are performed
automatically in DTS, Dolby Digital or PCM (2 channel
stereo) format. If no digital signal is being input, the
analog input terminals are selected.
Use this mode to play Dolby Digital signals.
Input mode
• The AVR-5805CI has an AUTO signal detection mode that
automatically identifies the type of incoming audio signals,
but is also equipped with a manual mode that can be
switched according to the type of input audio signals.
DTS (exclusive DTS signal playback mode):
Decoding and playback are only performed when DTS
signals are being input.
PCM (exclusive PCM signal playback mode):
Decoding and playback are only performed when PCM
signals are being input.
Note that noise may be generated when using this
mode to play signals other than PCM signals.