Filter
Top Products
122
Advanced Setup – Part 1
Setting the Channel Level for ZONE2
• Use this setting to adjust so that the playback level between
the different channels of ZONE2 is equal.
•From the ZONE2 listening position, listen to the test tones
produced from the speakers used in ZONE2 to adjust the
level.
• The level can also be adjusted directly from the remote
control unit ( page 95).
1
Press the CURSOR
DD
or
HH
button to select
“Channel Level” at the “Zone Setup” menu,
then press the
ENTER button.
• The “Channel Level” screen appears.
2
Press the CURSOR
FF
or
GG
button to select
“Auto” or “Manual”.
Auto:
Adjust the level while listening to the test tones
produced automatically from each speaker.
Example: When the “Auto” mode is selected
Manual:
Select the speaker from which you want to
produce the test tone to adjust the level.
Press the CURSOR
DD
or
HH
button to select
“Test Tone Start”, then press the
CURSOR
FF
button to select “Yes”.
4
-1
When “Auto” mode is selected:
Press the
CURSOR
FF
or
GG
button to adjust all
the speakers to the same volume.
• The test tones are emitted from each speaker in the
following order, at 4 seconds intervals the first time
and second time around, 2 seconds intervals the
third time around and on:
FL
SW
C
FR
SR
SL
3
The volume can be adjusted between –12.0 dB and
+12.0 dB in units of 0.5 dB.
4
-2
When “Manual” mode is selected:
Press the
CURSOR
DD
or
HH
button to select the
speaker used in ZONE2, then press the
CURSOR
FF
or
GG
button to adjust all the
speakers to the same volume.
Example: “Manual” mode is selected.
5
Press the ENTER button to enter the setting.
• The “Channel Level” screen reappears.
Example: When the volume is set to –11.5 dB while
the test tone is being produced from the
Front L ch speaker
•To cancel the settings, press the CURSOR
FF
button to select
“Level Clear” and “Yes” on the “Channel Level” screen,
then make the settings again.