Filter
Top Products
LED-PRO • User’s Guide 133
_K==oÉãçíÉ=`çåíêçä=mêçíçÅçä
LED-PRO Remote Commands
póëíÉã=~åÇ=bíÜÉêåÉí=oÉãçíÉ=`çãã~åÇë
The table below lists LED-PRO system and Ethernet remote commands.
içÖç=oÉãçíÉ=`çãã~åÇë
The table below lists LED-PRO Logo remote commands.
Table B-6. LED-PRO System and Ethernet Remote Commands
Command Description Page
DMSG mode Disable/Enable Debug messages 153
DMSG?
Query Debug message mode 153
ENETM
Set Ethernet Mode 153
EDHCP
Set Ethernet DHCP mode 154
EDHCP?
Query Ethernet DHCP mode 154
EECHO mode
Disable/Enable echo on Ethernet telnet window 154
EIP xxx.xxx.xxx.xxx
yyy.yyy.yyy.yyy
zzz.zzz.zzz.zzz
Sets Ethernet IP address, Subnet mask, default Gateway IP 154
EIP?
Query Ethernet IP address 154
EMAC?
Query Ethernet MAC address 154
SBAUD n
Adjust Serial Baud Rate 155
SBAUD?
Query Serial Baud Rate 155
SYSAV
Save System State 155
HELP [op]
Displays command list: op [A..Z] 155
LOADR
Run Loader Program 155
RESET
Factory Reset LED-PRO 155
WALLSTANDBY
Set LED Wall to standby mode 155
MINMODE
Set Minimum Delay Mode 156
MINSTAT
Query Minimum Delay Status 156
LOCKOUT
Locks or unlocks the front panel 156
Table B-7. LED-PRO Logo Remote Commands
Command Description Page
LOGOD Delete currently saved Logo image from Flash 156
LOGOL
Load currently saved Logo from Flash to Frame store buffer 156
LOGOS
Save current output image as Logo image to Flash 156
LOGOI
Query Logo resolution 156