Filter
Top Products
90 LED-PRO • User’s Guide
4. Operation
Using the Expert Mode Menu
• Set Static IP — select the Set Static IP function to display the SET IP Menu.
This menu enables you to manually set a subnet mast, gateway, and static IP
address when a DHCP server is not available. The menu is only accessible when
DHCP is Off.
Figure 4-73. Set IP Menu (sample)
To set a subnet mask, gateway and IP address:
a. Scroll to the Sub line, and press SEL to begin editing the subnet mask.
The first “quad” is highlighted.
b. Rotate the knob to select the desired value — from 000 to 255.
c. Press SEL to accept, and advance the edit cursor to the next quad.
d. Repeat for all remaining quads. When complete, the navigation cursor is
restored.
e. Scroll to the GW line, and press SEL to begin editing the gateway.
f. Repeat steps b through d for all remaining quads.
g. Scroll to the IP line, and press SEL to begin editing the IP address.
h. Repeat steps b through d for all remaining quads.
i. When complete, press ESC to return to the Ethernet Menu, and verify
that the IP address is correct. At this point, all new static IP values are
active.
Please note the following important points:
~ Only after setting the IP address will LED-PRO attempt to set the
Ethernet port.
~ An IP address of 000.000.000.000 indicates that you are not interested
in Ethernet communication, and to ignore the Ethernet port.
~ It takes several seconds for the unit to communicate with the Ethernet
port and set the IP address. During this time, the SEL key remains lit.
SET IP
> SUB 255.255.255.000
GW 192.168.000.001
IP 192.168.000.200
Important
Before using this menu, consult with your network
administrator to make sure that the assigned IP address is
valid, and that the Subnet mask and Gateway are set
appropriately. Ensure that you set the subnet mask and
gateway prior to setting the IP address.
Note
If desired, press ESC at any point before pressing SEL to
cancel all edits and leave the address value unchanged.