Filter
Top Products
HDMI-UTPRO-RX NetLinx Programming
97
Instruction Manual – HDMI-UTPRO-0808
* Both commands for setting the baud rate are accepted by the Receivers and work the same way. When the system is
rebooted or power cycled, the serial ports default to 9600, N, 8, 1.
HDMI-UTPRO-RX SERIAL SEND_COMMANDs (continued)
SET BAUD
Set the serial
communication parameters.*
Syntax:
SEND_COMMAND <DEV>,"'SET BAUD <baud>,<parity>,<data>,<stop>'"
Variables:
• baud = baud rates are: 115200, 57600, 38400, 19200, 9600, 4800, 2400, 1200.
• parity = N (none), O (odd), E (even)
• data = 8 data bits
• stop = 1 and 2 stop bits
Example:
SEND_COMMAND dvRXRS232,"'SET BAUD 19200,N,8,1'"
Temporarily sets the RX serial port's communication parameters to
19200 baud, no parity, 8 data bits, 1 stop bit.
TSET BAUD
Set the serial
communication parameters.*
Syntax:
SEND_COMMAND <DEV>,"'TSET BAUD <baud>,<parity>,<data>,<stop>'"
Variables:
• baud = baud rates are: 115200, 57600, 38400, 19200, 9600, 4800, 2400, 1200.
• parity = N (none), O (odd), E (even)
• data = 8 data bits
• stop = 1 and 2 stop bits
Example:
SEND_COMMAND dvRXRS232,"'TSET BAUD 19200,N,8,1'"
Temporarily sets the RX serial port's communication parameters to
19200 baud, no parity, 8 data bits, 1 stop bit.
TXCLR
Stop and clear all
characters waiting in the
transmit out buffer and stops
transmission.
Syntax:
SEND_COMMAND <DEV>,"'TXCLR'"
Example:
SEND_COMMAND dxRXRS232,"'TXCLR'"
Clears and stops all characters waiting in the RX serial port transmit buffer.
set baud rate with
SEND_COMMAN
D