Filter
Top Products
Installation and Setup
26
Instruction Manual – HDMI-UTPRO-0808
System Diagram
The diagram in FIG. 8 illustrates a basic A/V distribution system using an HDMI-UTPRO-0808 Matrix Switcher and
eight HDMI-UTPRO-RX Receivers.
Important: Each HDMI matrix switching output connector must be connected (with HDMI patch cable -
provided) to its corresponding HDMI transport input connector (1 to 1, 2 to 2, etc.).
Rack Installation and System Setup
The HDMI UTPro enclosure can be mounted in a standard EIA 19 in. (48.26 cm) rack. Rack installation ears are
included, and directions for mounting the rack ears are included in the rack installation instructions on page 28.
Important: The system requires at least one empty rack unit above and below the enclosure to allow
adequate airflow; three empty rack units are recommended.
Required items for rack installation:
Enclosure
Standard EIA 19 in. (48.26 cm) rack
Rack ears with 8 screws per kit
Screwdriver
Screws that fit your rack for mounting the enclosure
Standard US power cord (if shipped within the US)
Optional items for rack installation:
Surge-protector(s) – highly recommended
A laptop computer or PC with a null modem cable (for communication with the HDMI UTPro via the
Control / RS-232 port)
FIG. 8 System Diagram
AC
Display
Device
Display
Device
Display
Device
Display
Device
HDMI
Source Device
HDMI
Source Device
HDMI
Source Device
HDMI
Source Device
HDMI
Source Device
HDMI
Source Device
HDMI
Source Device
HDMI
Source Device
Ethernet cable (to LAN)
HDMI-UTPRO-RX HDMI-UTPRO-RX HDMI-UTPRO-RX
Display
Device
Display
Device
Display
Device
Display
Device
HDMI HDMI HDMI HDMI HDMI HDMI HDMI HDMI
UTP cable UTP cable UTP cable UTP cable
UTP cable UTP cable UTP cable
UTP cable
HDMI HDMI HDMI HDMI HDMI HDMI HDMI HDMI
HDMI-UTPRO-RX
HDMI-UTPRO-RX HDMI-UTPRO-RX HDMI-UTPRO-RX HDMI-UTPRO-RX
Power