Filter
Top Products
HDMI UTPro WebConsole
71
Instruction Manual – HDMI-UTPRO-0808
Admin Menu
Several configuration pages are included in the Configuration Manager, all of which are accessed via the Admin
drop-down menu (FIG. 44).
Click on an option in this menu to access each of the configuration pages, as described in the following sections. The
Restore Settings menu option restores the factory default settings on both the Security Settings page and the Port Settings
page.
Control Page
Select Control from the Admin menu to access the HDMI-UTPRO-0808 Control page (FIG. 45). Use this page to send
NetLinx programming control commands to the HDMI UTPro Matrix Switcher or the HDMI-UTPRO-RX Receivers
(Receivers must be connected). This page provides a rudimentary control method if a master connection is not available.
Control Commands
Note: Only ASCII-printable characters are supported.
To send commands to the HDMI UTPro:
1.
From the Device drop-down menu, select Hub (for the HDMI UTPro).
2. From the Port drop down menu, select the applicable port for the command (FIG. 45).
Port 1: SEND_COMMANDs
Port 2: SEND_COMMANDs to output control strings to a connected device
Port 3: reserved for future use
3. Enter the SEND_COMMAND in the Commands field on the left.
FIG. 44 Configuration Manager - Admin drop down menu
FIG. 45 Configuration Manager - HDMI-UTPRO-0808 Control page
Port 1 - main device port / IR Receiver
Port 2 - Serial (RS-232) port
Port 3 - IR device port
HDMI-UTPRO-RX
Port 1 - control and switching
Port 2 - output control strings to a
Port 3 - reserved for future use
HDMI UTPro
connected device