Filter
Top Products
Overview and General Specifications
23
Instruction Manual – HDMI-UTPRO-0808
Control Options
HDMI UTPro systems support two main protocols: TCP/IP and XNNet (protocol used by control panel). Several control
options are available. Multiple control methods can be used on the same system.
Native NetLinx Interface
The HDMI UTPro can be integrated with any NetLinx Central Controller and appears in NetLinx Studio (Version 3 or
higher is required) as a NetLinx device.
Front Control Panel
The HDMI UTPro comes standard with a front control panel. Even if another method of control is preferred, the control
panel can be used for system verification, redundant control, and troubleshooting.
AMX Control Devices
The HDMI UTPro is compatible with a number of AMX control devices. For control programming information, see the
instruction manual for the specific interface.
Third-Party Controllers
A third-party controller can also be attached to the Control (DB-9 serial) port on an HDMI UTPro enclosure (note that
this port cannot provide the additional NetLinx functionality which is available through the LAN 10/100 port). If using
a third-party controller, see the controller documentation for operating instructions.
System Diagnostics (Programmer’s Interface)
The HDMI UTPro displays system information in its splash screen for diagnostic purposes. The information indicates
the current status and well-being of the system components. The splash screen can be accessed using a terminal
emulation program (e.g., TeraTerm, PuTTY, or HyperTerminal). For additional information, see Appendix B on
page 106.