Filter
Top Products
Overview and General Specifications
18
Instruction Manual – HDMI-UTPRO-0808
Rear Panel Components (continued)
Serial Port (RJ-12) • Bi-directional RS-232
• Baud rates 115200, 57600, 38400, 19200, 9600, 4800, 2400, 1200 (default 9600)
• RJ-12 connector
NetLinx LED Blinks at 5 second intervals when a connection to a NetLinx Master is
established.
Status LED Non-functional.
Ready LED Solid green indicates that NetLinx has fully booted and is ready.
HDMI Matrix Switching Input
and Output Connectors
The HDMI matrix switching connectors are located on the upper-half of the rear panel.
The HDMI input and output connectors allow for the use of cables from source and
destination devices with HDMI connectors.
These connectors also have local DDC (Display Data Channel) support with plug-and-
play information provided by the HDMI UTPro.
• HDMI inputs (IN 1-8) accept inputs from up to 8 HDMI source devices.
• HDMI outputs (OUT 1-8) connect to HDMI inputs (INPUT 1-8) on the bottom
(see HDMI Transport Input Connectors below).
Note: Refer to the “Digital Video - HDMI Specifications” table for complete specifications
(see page 19).
HDMI Transport Input
Connectors
The HDMI inputs (INPUT 1-8) accept HDMI patch cables (provided) from the HDMI
matrix switching outputs (OUT 1-8).
UTP RJ-45 Transport Output
Connectors
The RJ-45 outputs (OUTPUT 1-8) provide connectivity for up to 8 HDMI-UTPRO-RX
Receivers (FG1403-20) via UTP cable.
Other AMX Equipment
Included Accessories • 8 HDMI-UTPRO-RX Receivers (FG1403-20); for specifications, see page 22
• 8 desktop power supplies (12 V 1.25 A) with power cord (FG1090-155)
• 8 connection cables (connect between HDMI matrix switching outputs and the HDMI
transport inputs)
• 1 power cord (standard US power cords are provided for installations within the US)
• 2 rack mounting brackets for the enclosure
Note: No A/V interface cables are supplied.
Compatible / Optional
Equipment
• UDM-RC05 IR Remote Control (FG1402-70)
• IR01 Infrared Emitter Module (FG-IR01)
• IR03 External Infrared Receiver Module (FG-IR03)
• MIO-R1 Mio Modero
®
R-1 Remote Control (FG147)
• RS-232 Serial (DB-9/RJ-12) connection cable (FG-RS01)
• RS-232 Serial (DB-9/RJ-12) connection cable kit with adapters (FG-RS01K)
• 6 ft. (1.83 m) Ethernet crossover cable (CA2179-02)
• Surface Mounting Bracket kit - for Receivers (FG525)
Compatible IR
equipment