Filter
Top Products
Overview and General Specifications
15
Instruction Manual – HDMI-UTPRO-0808
HDMI-UTPRO-RX Receiver
The HDMI-UTPRO-RX Receiver is used in conjunction with the HDMI UTPro 8x8 to assist in the transport of HDMI
signals over UTP cable. Cables from the HDMI UTPro are connected to the HDMI-UTPRO-RX Receivers, which in
turn are connected to the destination devices. In addition, the Receiver has ports for serial communication and IR control
(FIG. 7).
The size of the Receiver makes it easy to mount near or behind a high definition monitor. A Surface Mounting Bracket
kit (FG525) is available for this purpose. The Receivers should not be stacked to allow for adequate cooling. If mounting
in a rack using some type of tray, a minimum of one empty rack unit above and below is recommended (see the section
on “Airflow Restriction” on page 24).
HDMI-UTPRO-RX Components
The front of the HDMI-UTPRO-RX Receiver has an LED Power indicator.
The rear components on the HDMI-UTPRO-RX Receiver include the following from left to right:
Power jack – 12 V to 24 V DC power jack (desktop power supply provided*)
Serial port (RJ-12) – optional serial communication for control of the monitor (see page 16)
IR Rx port – supports generation of NetLinx key presses (channel events) from AMX remote controls
(see “IR Control” on page 16)
IR Tx port – supports wired control of connected IR devices (see “IR Control” on page 16)
HDMI Out connector – HDMI connector connects via HDMI cable to the destination device
Input connector – RJ-45 connector connects via UTP cable to an RJ-45 output connector on the HDMI UTPro
* The automatically adjusting universal 110/220 IEC power supply is ENERGY STAR
®
qualified to ensure maximum
efficiency and savings.
FIG. 7 HDMI-UTPRO-RX Receiver