Filter
Top Products
Appendix C – Managing Configuration Files
118
Instruction Manual – HDMI-UTPRO-0808
Restoring the Automatic Configuration
To restore the automatically constructed configuration:
1.
Connect the system to a PC (see page 39).
2. Open a terminal emulation program (e.g., TeraTerm, PuTTY, or HyperTerminal).
3. Enter: ~def! to restore the configuration.
4. Wait for a “V” to be returned (may take several seconds).
Device Discovery Support
XNConnect v2.10.0 supports Device Discovery (firmware v1.4.0 or higher is required). Typically the default
configuration string generated by XNConnect is all that is necessary. However, certain conditions may warrant a custom
string, such as the need to limit the VMs that are available for control by the AMX control system. Or a need may exist
to limit the features available for a system, e.g., omitting the ability to adjust input gain, but leaving support for output
volume. To customize the configuration string, see the XNConnect Help file topic “Device Discovery Config String
Input.”
Caution: Restoring the automatically constructed configuration will result in the loss of all custom .xcl
configuration file modifications (local presets, passwords, etc.).