Filter
Top Products
HDMI UTPro WebConsole
78
Instruction Manual – HDMI-UTPRO-0808
Clock Manager - Daylight Savings (only available if Network Time is selected)
The options on the Daylight Savings Manager page allows you to enable and disable daylight savings and to specify
daylight savings start and end times.
To adjust Daylight Savings setting in the Clock Manager:
1.
From the Admin drop down menu, select Clock Manager (or select Mode from the Clock Manager submenu).
2. Under Time Sync, select Network Time and click Accept.
3. Click the Daylight Savings tab.
4. Modify any of the settings on the Daylight Savings page and click Accept.
Click Accept to save the changes. Changes on the Daylight Savings Manager page take effect immediately.
Click Cancel to exit the page without saving any changes.
FIG. 53 Clock Manager - Daylight Savings Manager page
Clock Manager - Daylight Savings Manager
Daylight Savings Use these radio buttons to turn daylight savings time on and off (default = Off).
Offset Use these drop-down menus to specify the amount of time to offset the clock for daylight savings.
Starts These options allow you to specify when to start using daylight savings time. Select a month and
time to start from the drop-down menus.
• Select Fixed to start daylight savings at a specific Day, Month and Time (an additional field for
Day is provided when this radio button is selected).
• Select Occurrence to start daylight savings at a specified occurrence (additional fields for Week
of the Month, and Day of the Week are provided)
Ends These options allow you to specify when to stop using daylight savings time. Select a month and
time to start from the drop-down menus.
• Select Fixed to end daylight savings at a specific Day, Month and Time (an additional field for
Day is provided when this radio button is selected).
• Select Occurrence to end daylight savings at a specified occurrence (additional fields for Week
of the Month, and Day of the Week are provided).