Filter
Top Products
Overview and General Specifications
16
Instruction Manual – HDMI-UTPRO-0808
IR Control (Optional)
Compatible IR Control Options: UDM-RC05 or MIO-R1
The following three items are required for IR control via the HDMI-UTPRO-RX Receiver. (These items are not included
with the HDMI UTPro but must be ordered separately.)
UDM-RC05 – The UDM-RC05 (FG1402-70) remote control can be used as a control interface to a UTPro
system. If this remote is selected, the key presses will generate channel events from the receiver which may
be processed in a connected master and used in the same way as touch panel button presses.
Or
MIO-R1 – The Mio Modero
®
R-1 Remote (FG147) is an IR remote control unit that can communicate with
an HDMI-UTPRO-RX Receiver and provides custom control features. (Requires the KeypadBuilder
application for programming of the remote.)
IR03 – External IR Receiver Module (FG-IR03). The IR03 connects to the IR Rx jack on the
HDMI-UTPRO-RX, allowing IR signals to be received from a compatible IR remote control like the
UDM-RC05. The IR03 allows the HDMI-UTPRO-RX to be placed behind the display device if desired.
IR01 – IR Emitter Module (FG-IR01). The IR01 connects to the IR Tx jack on the HDMI-UTPRO-RX,
allowing IR signals to be sent to the display device.
Serial Control (Optional)
The Serial port on the HDMI-UTPRO-RX Receiver is an RJ-12 connector and displays in NetLinx Studio as Port 2 of
the Receiver. This port may require an adapter cable to connect to the external serial device under control. The
information for this port starts on page 36. Cable adapter information is on page 37. The RJ-12 pinout is on page 38.
Serial Port - Default Communication Settings
The default serial settings are listed in the table below. The settings can be altered by sending
SEND_COMMANDs to Port 2 of the Receiver (see page 91).
Default Serial Settings
Baud Rate 9600
Data Bits 8
Parity None
Stop Bits 1
Flow Control None