Filter
Top Products
Operating the Control Panel
55
Instruction Manual – HDMI-UTPRO-0808
Locking and Unlocking (Lock Mode)
Locking the panel prohibits access to the system and can prevent accidental switching. The control panel can be locked
by entering a sequence of keys. The factory default password is the first five keys in the top row (Inputs 1, 2, 3, 4 and
Output 1). The password can only be changed by using XNConnect (see page 114).
Note: Locking the control panel only locks out operations from the front panel keys. While the control panel is
locked, SEND_COMMANDs and BCS commands are still fully functional through their normal ports. Neither
protocol has commands for locking or unlocking the control panel.
The panel remains locked if the power is cycled.
Locking the Control Panel
The following example uses the default password of “1 2 3 4 1” entered using the first five keys in the top row (Inputs 1,
2, 3, 4 and Output 1).
If you enter the wrong password while attempting to lock the control panel, an invalid password message appears and the
Cancel Key flashes. Press the Cancel Key to clear the error and then enter the correct password.
Note: For security purposes, the Input Keys do not turn white when pressed while locking and unlocking the
panel.
To lock the control panel:
1.
Press the Function Key.
The Function menu appears.
2. Locate Lock Panel by scrolling with the Control Dial.
3. Press the Select Key.
The system is in Lock Mode.
4. In the following order, press Input Keys 1, 2, 3, 4 and Output Key 1 (default password).
The panel is locked, and all Input and Output Keys turn off.