Filter
Top Products
1/99 SMV 3000 Transmitter User’s Manual 43
5.4 Write Protect Option
Write Protect Option
The SMV 3000 transmitters are available with a “write protect option”. It
consists of a jumper located on the transmitter’s Main Printed Circuit
Board (PCB) under the temperature measurement (Daughter) PCB that
you can position to allow read and write access or read only access to the
transmitter’s configuration database. When the jumper is in the read only
position, you can only read/view the transmitter’s configuration and
calibration data. Note that the factory default jumper position is for read
and write access. There is no need to check jumper position unless you
want to change it.
Figure 19 shows the location of the write protect jumper on the electronics
module for SMV 3000 transmitters.
Figure 19 Write Protect Jumper Location and Selections with Daughter PCB Removed.
Screw
Temperature
Input
Connector
Daughter PWA
Screw
PWA
Connector
PROM
Location
Flex Tape
Connector
Power
Connector
Write
Protect
Jumper
Screw
PWA
Connector
Main PWA
Plastic
Bracket
Read
and
Write
Read
Only
W
R