Filter
Top Products
32 SMV 3000 Transmitter User’s Manual 1/99
4.5 Wiring SMV 3000 Transmitter, Continued
TPS/TDC 3000
reference
Transmitters that are to be digitally integrated to our TPS/TDC 3000
systems will be connected to the Smart Transmitter Interface
Multivariable Module in the Process Manager, Advanced Process
Manager, or High Performance Process Manager through a Field
Termination Assembly. Details about the TPS/TDC 3000 system
connections are given in the PM/APM Smartline Transmitter Integration
Manual PM12-410 which is part of the TPS/TDC 30000 system bookset
and in Appendix A of this manual.
Optional meter
The SMV 3000 transmitter can be equipped with an optional analog
output meter.
The analog meter provides a 0 to 100% indication of the transmitter’s
output through traditional pointer and scale indication. It can be mounted
integrally on top of the terminal block in the electronics housing with a
meter end cap or remotely in a separate housing.
You connect the analog meter across the meter terminals on the terminal
block with the metal jumper strap removed. For more detailed information
on wiring the analog meter, refer to control drawing 51404251 (for
intrinsically safe installations) and external wiring diagrams 51404250 and
51404251 (for non-intrinsically safe installations) in Section 13.
Wiring connections
The procedure in Table 7 shows the steps for connecting power/loop and
temperature sensor input wiring to the transmitter. For loop wiring
connections, refer to the control drawing 51404251 for intrinsically safe
loops and external wiring diagrams 51404250 and 51404251 for non-
intrinsically safe loops in Section 13 for details. If you are using the SMV
transmitter with our TPS/TDC 3000 control systems, refer to the
appropriate TPS/TDC 3000 manual or Appendix A in this manual.
ATTENTION
All wiring must be installed in accordance with the National Electrical
Code (ANSI/NFPA 70) and local codes and regulations.
Table 7 Wiring the Transmitter
Step Action
1
Loosen end-cap lock and remove electronic housing end-cap cover.
2
If transmitter is supplied with an optional integral meter, unsnap meter
from terminal block to expose wiring connections.
Continued on next page