Furuno RC-1500-1T Stereo System User Manual


 
3-4
8. If you selected "Channel" enter ITU channel number (see ap-
pendix) or User channel number (see page 3-9).
If you selected the "ScanTable", press the [ ] key to show a
scan group list registered (see page 3-7). Select a scan group
name by using the [ ] or [ ] key followed by pressing the
[Enter] key.
Scanning Group List
MARITEX-A
MARITEX-B
MARITEX-C
FURUNO
CHOUSHI
MARITEX-F
Note: The ScanTable is only available for macro-operation. See
page 7-8.
9. Press the [Enter] key. The prompt OK/CANCEL asks for veri-
fication of data.
CREATE
CHANGE
O K
CANCEL
Figure 3-6 OK/CANCEL prompt
10. If the data are correct, press the [Enter] key. (To cancel entry,
place cursor on CANCEL by pressing the [ ] key, and then hit
the [Enter] key. Data entered are erased.)
To register other stations, select Create again and then press the
[Enter] key. Repeat steps 3 – 10.
To confirm the data registered, press the [ ] key to get into the
Station Set Up window.
Note: If you enter a station which exists the indication "Station by
that name already exists. Press any key to escape." appears. Press
any key to return to the Station List. Check the list.
Editing/Deleting Stations
1. Press function key [F5] and then the [1] key.
2. Select station from the Station List.
3. Select Change and press the [Enter] key.