Filter
Top Products
Selecting Live Mode and Pushing or Pulling Data
To switch from Emulate to Live mode:
1. Select the desired connection to the DMP128 and make the proper connections.
NOTE: Extron recommends connection via the Ethernet LAN port when using
DSPConfigurator.
2. Click the Mode Live button (see
b
in figure 55). The communication type
selection dialog box appears.
or
or
Extron USB device
2
3
4a
4b
4c
5a
5b
5c
3
6a
6b
3
Figure 55. Selecting Live Mode
3. Click either:
• TCP/IP (for connection via the LAN port (preferred) — proceed to step 4,
• RS-232 (for connection via either of the rear panel RS-232 ports — proceed to
step 5,
• USB (for connection via the front panel configuration port — proceed to step6.
4. If TCP/IP was selected in step 3:
a. Observe the IP address field in the IP connection dialog box. The field displays
the last IP address entered.
• If the IP Address field is correct, proceed to step 4b.
• If the address is not correct, either click in the IP Address field and enter
the IP address or click on the button ( ) to open a drop-down list and select
from among recently used addresses. Proceed to step 4b.
NOTE: If the local system administrators have not changed the value,
the factory-specified default, 192.168.254.254, is the correct value
for this field.
b. If the device is password protected, click in the Password field and enter the
appropriate administrator password.
c. Click OK.
The Synchronize with Device dialog box (see figure 56 on page 92) appears. Proceed
to step 7.
DMP128 • Software Control 90