Filter
Top Products
DMP Software
This section describes the control software for the DMP128, including:
• Software Control
• Embedded Web Pages
• Windows-based Program Control
• DSP Configurator Program Basics
• DigitalI/OPorts
• Emulate Mode and Live Mode
• DSP Configurator Windows Menus
• Optimizing Audio Levels
• Signal Path Building Blocks
Software Control
The DMP128 can be controlled using the DSPConfigurator software, using SIS
commands through hyper terminal or DataViewer, or using embedded WebPages.
The DMP128 has the following connection options:
• RS-232 — One single stack 3-pole, 3.5 mm captive screw connector is used for
bi-directional RS-232 (
±
5 V) serial control.
See “Rear Panel Features and Cabling” on page 6, for additional details on
connecting the RS-232 port.
• LAN — 10 Mbps, 100 Mbps, halfduplex, full duplex connections are supported. Two
LEDs indicate connection and activity status. The device has the following default
Ethernet configurations:
IP Address: 192.168.254.254 Default Gateway: 0.0.0.0
Subnet Mask: 255.255.0.0 DHCP: OFF
See “Rear Panel Features and Cabling” on page 6, and “Connection
Options” on page 113 for additional details on connecting the LAN.
• USB 2.0 — A Mini B-type USB connector located on the front panel (duplicated
on the rear panel) provides high-speed USB 2.0 connectivity to a host computer,
backward compatible to 1.0.
DMP128 • Software Control 14