Filter
Top Products
Save Preset
A preset may be saved in either Emulate mode or Live mode.
Saving a preset in emulate mode stores that preset in the currently open file. The
DSPConfigurator file must then be saved to disk via File menu > Save (recommended),
and/or pushed to the device after a connection is established. This differs from live mode
where the created preset is saved in real-time to the device and becomes part of the
configuration file.
To save a preset use the following instructions:
1. Highlight the desired preset block(s) by using left click, <Ctrl + left click>, <shift + left
click> or drag around the desired blocks.
2. Select Tools > Presets > Save Preset in the main structural menu.
3. Select a preset number. In the Preset Name box, unused presets are named
“unassigned.” To create a new preset, select an unused preset number and type a
preset name. If no name is entered, a default name will be assigned. To overwrite an
existing preset, select a preset with a name other than “unassigned.”
Figure 58. Save Preset
4. Click OK to save the preset, or Cancel to stop the save preset operation.
DMP128 • Software Control 95