Filter
Top Products
2. The USB driver installer is launched. When the installer has completed the installation
of the USB drivers, the following screen appears:
Figure 14. Successful USB Driver Installation
3. Click Finish.
USB driver installation is complete.
DSP Configurator Program Basics
Starting the program
NOTE: Extron recommends connection via the Ethernet LAN port for running the
DSPConfigurator program.
To run the DSP Configurator Program, click
Start > Programs > Extron Electronics > DSP Configurator > DSP Configurator.
The DSP Configurator program starts in Emulate mode (see figure 15, next page). Also
see “Emulate Mode and Live Mode” on page 89.
Using the program
In the DSP Configurator Emulate mode, audio parameters may be selected, then
transferred to the DMP128 by switching to Live mode (while connected to a DMP128).
Audio settings can also be tailored while connected to the DMP128 which allows
real-time auditioning of the audio output as adjustments are made
(see “Emulate Mode and Live Mode” on page89).
The main screen contains controls for the input and output channels, virtual sends and
returns, expansion sends and returns, and other information used in the operation of the
DMP128. There is too much information contained on the main screen to enable viewing
of the entire mix board at one time so several methods are provided to scroll through the
GUI.
DMP128 • Software Control 18