Filter
Top Products
2. Click Next (
g
in figure 74 on the previous page). The program extracts and places the
firmware files in a folder identified in the InstallShield Wizard dialog box.
NOTE: Write down the folder where the firmware file is saved.
3. Click Finish (
h
in figure 74) to exit the program.
4. Connect the PC to the device via the Ethernet port.
5. Access the device using the HTML pages (see “Download the Startup Page” on
page137).
6. Click the Configuration tab.
7. Click the Firmware Upgrade link.
8. Click the Browse button. An open file dialog box appears.
9. Navigate to the folder where the firmware upgrade file was saved. Select the file.
NOTE: Valid firmware files must have the file extension ‘.S19’. Any other file
extension is not a firmware upgrade. The original factory-installed firmware is
permanently available on the device. If the attempted firmware upload fails for
any reason, the device automatically reverts to the factory-installed firmware.
10. Click the Open button.
11. Click the Upload button. The firmware upload to the device may take a few minutes.
DMP128 • HTML Operation 147