Filter
Top Products
Tools
The Tools menu (see right) contains these selections:
• Clear All Groups — clears all
group members and group master
parameters. Soft limits are also
cleared.
• Increment/Decrement Simulator
— allows the user to test increment/
decrement values (see below for
more information)
• Refresh All Group Data — Updates
group members and group master parameters.
• Group Details Report — generates a report, listing all group masters and membership
(see next page for more details).
Increment/Decrement Simulator
The Increment/Decrement Simulator provides a control for increment and decrement, with the
ability to set increment and decrement values. This control is temporary, since this value is not
remembered in the device.
To use the Increment/Decrement Simulator:
1. Select Tools > Increment/Decrement Simulator from the Tools menu.
2. Select the group to be controlled from the Select Group drop-down list. The following
dialog box appears:
Figure 53. Increment/Decrement Simulator Dialog Box
NOTE: The Number of Group Members: readout indicates the number of
controls to be affected.
3. Enter an increment value and a decrement value. The default value is 1.
NOTE: The size of the increment can be changed by typing a value in the
Increment Value or Decrement Value field. Values can be as large as the
maximum range of the control or as fine as 0.1dB. For groups controlling
mute, 1 is the only valid value.
4. Click the Increment and Decrement buttons as needed. The group master control
increases or decreases by the set value to the top or bottom of its soft limit range.
NOTE: When set, soft limits cannot be exceeded.
DMP128 • Software Control 86