Filter
Top Products
68
Legacy Analyzer Command List
Table of All Legacy Analyzer Commands
TRIGPOL Trigger polarity N/A N/A Yes Page 342
TRMATH Executes specified trace math at
end of sweep
No No N/A
TRPRST Sets trace operations to their
preset values
No No N/A
TRSTAT Returns current trace states to
controller
Yes Yes N/A Page 343
TS Takes a sweep Yes Yes Yes Page 344
TVLINE Selects which horizontal line of
video to trigger on
N/A N/A N/A
TVLSFRM Selects the type of video frame
to trigger on
N/A N/A N/A
TVSTND TV standard N/A N/A N/A
TVSYNC Selects polarity of video
modulation to trigger on
N/A N/A N/A
TWNDOW Formats trace information for
FFT.
N/A N/A No
UNTIL Conditional Programming
(Repeat…Until…)
No No No
UP Increases active function value
by applicable step
N/A N/A N/A
UR Upper right x-y recorder output
voltage at rear
No No N/A
USTATE Configures user defined states No No N/A
VARDEF Variable definition No No No
VARIANCE Returns the amplitude variance
of specified trace
No No No
VAVG Turns video averaging on or off Yes Yes Yes Page 345
VB Video Bandwidth Yes Yes Yes Page 347
VBO Video Bandwidth Coupling
Offset
Yes Yes N/A Page 349
VBR Video Bandwidth Ratio N/A N/A Yes Page 350
Table 2-1 Alphanumeric List of all Legacy Commands Showing their N9061A Support
Command Description 8566 8568 8560
Series
Page for
Further
Details