Filter
Top Products
56
Legacy Analyzer Command List
Table of All Legacy Analyzer Commands
LIMIFT Select frequency or time limit
line
N/A N/A N/A
LIMIHI Upper limit N/A N/A N/A
LIMILINE Limit line N/A N/A N/A
LIMILO Lower limit N/A N/A N/A
LIMIMIRROR Mirror limit line N/A N/A N/A
LIMIMODE Limit line entry mode N/A N/A N/A
LIMIPURGE Disposes of current limit line,
not limit line table
N/A N/A Yes Page 221
LIMIRCL Load stored limit line into limit
line table
N/A N/A No
LIMIREL Determine whether limit line
values absolute/relative
N/A N/A Yes Page 222
LIMISAV Save contents of limit line table
for recall
N/A N/A No
LIMISEG Define slope & offset of limit
line segments
N/A N/A N/A
LIMISEGT Enter limit line segment for
sweep time
N/A N/A N/A
LIMITEST Compare active trace data to
limit line parameters
N/A N/A Yes
LIML Amplitude value for limit line
segment in lower limit line
N/A N/A Yes Page 223
LIMM Middle amplitude value for
limit-line segment
N/A N/A Yes
LIMTFL Specifies a flat limit-line
segment
N/A N/A No
LIMTSL Specifies a sloped limit-line
segment
N/A N/A Yes Page 224
LIMU Amplitude value for limit line
segment in upper limit line
N/A N/A Yes Page 225
LINFILL Line fill N/A N/A N/A
LL Provides lower left recorder
output voltage at rear
No No N/A
Table 2-1 Alphanumeric List of all Legacy Commands Showing their N9061A Support
Command Description 8566 8568 8560
Series
Page for
Further
Details