Filter
Top Products
44
Legacy Analyzer Command List
Table of All Legacy Analyzer Commands
ADD Add No No No
ADJALL LO & IF adjustment N/A N/A Yes Page 99
ADJCRT Adjust CRT alignment N/A N/A No
ADJIF Adjust IF N/A N/A No
AMB Trace A − trace B -> trace A Yes Yes Yes Page 100
AMBPL Trace A − trace B + Display
Line -> trace A
Yes Yes Yes Page 101
AMPCOR Applies amplitude correction at
specified frequencies
N/A N/A No
AMPCORDATA Amplitude correction data N/A N/A No
AMPCORSAVE Save amplitude correction data N/A N/A No
AMPCORSIZE Amplitude correction data array
size
N/A N/A No
AMPCORRCL Amplitude correction recall N/A N/A No
AMPLEN Amplitude correction length N/A N/A N/A
ANLGPLUS Turns on or off the Analog+
display mode
N/A N/A N/A
ANNOT Display Annotation Yes Yes Yes Page 102
APB Trace A + trace B -> trace A Yes Yes Yes Page 103
ARRAYDEF Defines an array N/A N/A No
AT Input Attenuation Yes Yes Yes Page 104
AUNITS Amplitude Units Yes Yes Yes Page 106
AUTO Auto couple N/A N/A N/A
AUTOCPL Auto couple N/A N/A Yes Page 108
AUTOEXEC Turns on or off the function
defined with AUTOFUNC
N/A N/A No
AUTOFUNC Defines a function for automatic
execution
N/A N/A No
AUTOSAVE Automatically saves trace N/A N/A No
AVG Average No No No
AXB Exchange Traces A & B Yes Yes Yes Page 109
Table 2-1 Alphanumeric List of all Legacy Commands Showing their N9061A Support
Command Description 8566 8568 8560
Series
Page for
Further
Details