Filter
Top Products
23
Getting Started
Hardware and Firmware Requirements for N9061A
Hardware and Firmware Requirements for N9061A
One of the following Agilent signal analyzers is required to run the N9061A application.
For maximum compatibility, you should select an X-Series analyzer that equals or exceeds the frequency
range of the legacy analyzer you are replacing (currently not possible for the 8564E/EC or 8565E/EC).
The frequency limits of the legacy instruments are listed below.
Table 1-1 Compatible Agilent PXA Series Signal Analyzers
Analyzer Model
Number
Upper Frequency Limit Firmware
N9030A-503 3.6 GHz Rev A.04.00 or later
N9030A-508 8.4 GHz Rev A.04.00 or later
N9030A-513 13.6 GHz Rev A.04.00 or later
N9030A-526 26.5 GHz Rev A.04.00 or later
Table 1-2 Compatible Agilent MXA Series Signal Analyzers
Analyzer Model
Number
Upper Frequency Limit Firmware
N9020A-503 3.6 GHz Rev A.01.64 or later
N9020A-508 8.4 GHz Rev A.01.64 or later
N9020A-513 13.6 GHz Rev A.01.64 or later
N9020A-526 26.5 GHz Rev A.01.64 or later
Table 1-3 Compatible Agilent EXA Series Signal Analyzers
Analyzer Model
Number
Upper Frequency Limit Firmware
N9010A-503 3.6 GHz Rev A.01.64 or later
N9010A-507 7 GHz Rev A.01.64 or later
N9010A-513 13.6 GHz Rev A.01.64 or later
N9010A-526 26.5 GHz Rev A.01.64 or later
Table 1-4 Frequency Ranges of the Legacy Analyzers
Remote Language Start Frequency Stop Frequency
8560E/EC 30 Hz 2.9 GHz
8561E/EC 30 Hz 6.5 GHz