A SERVICE OF

logo

Open as PDF
next previous
Template 04_NetworkingWireless.fm
126 GL-1020 Administrator’s Guide
SETTING WIRELESS NETWORK PROTOCOL PROPERTIES
The Administration > Setup > Wireless Network page allows you
to set up the protocols used by client workstations to
communicate with the network via the wireless NIC installed in
the controller. You must configure the wireless protocols before
end users can access the wireless network.
By default, all network protocols are enabled.
You must be logged in as an administrator to set wireless network
protocol properties.
Enabling/Disabling the Wireless Card
1 On the Administration tab, click the
Setup subtab.
2Click the
Wireless Network link.
The Wireless page opens.
Sample Wireless page
3 In the Device area, click the Wireless Card drop-down list.
4 Select
Enable or Disable.
5Click
Save.