Template 04_TAConfigureWirelessProperties.fm
104 GL-1020 Administrator’s Guide
11 Select the Transmit Power from the drop-down list box.
12 Enter the number of Data Retries.
13 Enter the Fragment Threshold.
14 Enter the RTS Threshold.
15 Enter the RTS Retry Limit.
16 Click
Save.
For more information on wireless NIC settings, consult the Cisco
Aironet Wireless LAN Adapters 340 and 350 Series Quick Start
Guide.
Troubleshooting
Problem Solution
Transfer rate says “No
connection”
Verify the access point is
working
Transfer rate says “No
connection”
Verify SSID matches the
access point
Transfer rate says “No
connection”
Verify WEP against the access
point
There is a connection to the
access point and the printer is
not visible on the network
Verify that the indicated
settings on the Intel card are all
disabled. If it still fails, increase
the Transmit Power Setting.
There is a connection to the
access point, the authentication
mode is Open System, and the
printer is not visible on the
network
Verify that the indicated
settings on the Intel card are all
disabled. If it still fails, make
sure that the WEP key of the
client and AP match.
