Filter
Top Products
43
GB
Additional Information
Inputs/outputs
i.LINK S200 Jack type: 4-pins to 4-pins
General
Power requirements 230 V AC, 50/60 Hz
Power consumption 18 W
Dimensions (approx.) 430 × 70 × 315 mm (w/h/d) incl.
projecting parts and controls
Mass (approx.) 4.4 kg
Supplied accessories
See page 10.
US and foreign patents licensed from Dolby Laboratories
Licensing Corporation.
Design and specifications are subject to change without notice.
Display Messages
The following table explains the various messages that
appear in the display. Messages are also displayed by the
deck’s Self-Diagnosis function (see page 46).
Message Meaning
Auto Cut The Auto Cut function is on (page 16).
Blank Disc A new (blank) or erased MD has been
inserted.
CANNOT LINC You cannot record from the selected
component. Select another component.
This indication also appears when
communiation erro has occurred between
the deck and the selected component
while recording. In this case, press x on
the deck to cancel recording, and then
start recording over again.
Cannot Copy An attempt was made to make a second
copy from a digitally dubbed MD (page
14).
Cannot Edit An attempt was made to edit a
premastered MD, to edit the MD while
Programme or Shuffle Play is selected, or
to change the recording level of an MD
recorded in LP2 or LP4 mode.
Cannot Synchro Communication between the MD deck
and the CD player failed during CD
Synchro-recording.
Disc Full The MD is full (page 41).
Impossible The deck cannot do the specified
operation (pages 14 and 31).
Incomplete!! S.F Edit (changing the recording level
after recording, Fade-in, or Fade-out)
operation failed because the deck was
moved while the recording was in
progress or the MD is damaged or dirty.
Message Meaning
Initialize (flashing) The Setup Menu settings have been lost.
Or the contents recorded by timer have
disappeared over time and are not be
available for saving to disc, or
Programme Play could not be activated
since the programme has disappeared
over time.
(The message flashes for about four
seconds when you turn on the deck by
pressing +/1.)
Name Full The naming capacity of the MD has
reached its limit (about 1,700 characters).
NEW CONNECT A new component is connected within
the i.LINK configuration. This indication
also appears when a mains lead or an
i.LINK connecting cable of the
component within the configuration is
connected or disconnected.
No Change You performed S.F. Edit without
specifying the recording level, resulting
in no change of recording level.
No Disc There is no MD in the deck.
No Name The track or disc has no name.
No Program!! You tried to start Programme Play when
no programme exists.
Premastered An attempt was made to record on a
premastered MD.
ProgramFull The programme contains the maximum
number of tracks. You cannot add any
more tracks.
REMOTE The MD deck is being controlled by an
external device connected to the deck.*
While this indication appears, all the
buttons on the deck and the remote
become inoperable.
S.F Edit! You tried to do another operation while
the S.F Edit is in progess. You cannot
perform any other operations at this
time.
S.F Edit NOW You pressed +/1 while in S.F Edit
(changing the recording level after
recording, Fade-in, or Fade-out) mode. If
you turn off the deck while in S.F Edit
mode, any changes that you have made
will not saved properly. Finish the
editing and exit S.F Edit mode before
turning off the deck. If you wish to turn
off the deck at this time, press +/1 again
while this indication appears in the
display.
Smart Space The Smart Space function is on (page 16).
TOC Reading The deck is checking the TOC (Table Of
Contents) on the MD.
*
If “REMOTE” appears under other circumstances, turn kff the deck,
then turn it on again.