Filter
Top Products
13
GB
Recording on MDs
Operations you may want to do during recording
To Press
Stop recording x
Pause recording HX (or X)
Resume recording after pausing HX (or press N or X)
Change the display information DISPLAY (page 9)
Eject the MD A after stopping recording
When you pause recording
The track number increases by one. For example, if you
paused recording while recording track 4, the track
number will be 5 when you resume recording.
To prevent accidental erasure of the recorded
material
To make it impossible to record on an MD, slide the
record-protect tab in the direction of the arrow (see
illustration below) to open the slot. To enable recording,
close the slot.
If the programme source does not appear in step 4
An error may have occurred while the MD deck was
reading information about the programme source. Or, the
MD deck may be incapable of receiving information from
certain components. The indications in the following
table may appear at this time:
Indication Meaning
“Disc”, “Tuner”, etc. The MD deck has read in only general
information about the component.
“Unknown” The MD deck cannot receive any
information about the component. The
connection, however, remains operative.
“No Device” No component is connected to the MD
deck.
“CANNOT LINC” You cannot record from the selecetd
component.
z
To play the tracks you just recorded
Press HX (or N) immediately after stopping recording.
The deck starts to play from the first track of the material just
recorded.
z
To play from the first track of the MD after recording
1 Press x again after stopping recording.
2 Press HX (or N).
The deck starts to play from the first track of the MD.
Note
While recording, do not disconnect any mains leads or i.LINK
connecting cables within the i.LINK configuration. If you do so,
recording may not be done properly.
Bottom side of the MD
Record-protect tab
Slide in the
direction of arrow