Filter
Top Products
Editing Recorded MDs
32
GB
Naming Tracks or MDs Z
You can enter a name for a recorded MD as well as for
individual tracks. Names can consist of uppercase and
lowercase letters, numbers, and symbols. A total number
of 1,700 characters can be stored for all the names on the
MD.
m/M
YES
CLEAR
–
+
?/1
.>mM
N
MENU/NO
NAME EDIT/
SELECT
Xxz
789
>10
10
/0
1
23
4
56
./>
Note
If you name a track while it is being recorded, be sure to finish
the naming operation before the track ends. If the track ends
before you finish, the entered character data will be discarded
and the track will remain unnamed. Also, you can‘t name tracks
while the deck is recording over existing material.
Naming a track or MD
1 Press NAME EDIT/SELECT while the deck is in one
of the operating statuses listed below, depending
on what you want to name:
To name Press while the deck is
A track Playing, paused, recording, or stopped with
the track number displayed
The MD Stopped with no track number displayed
A flashing cursor appears in the display.
2 Press NAME EDIT/SELECT repeatedly to select the
character type.
To select Press repeatedly until
Uppercase letters and symbls* “Selected ABC” appears in
the display
Lowercase letters and symbls* “Selected abc” appears in the
display
Numbers “Selected 123” appears in the
display
* The following symbols can be selected: ‘ _ / , . ( ) : ! ?
A
3 Enter a character.
If you’ve selected uppercase or lowercase letters
1 Press the corresponding letter/number button
repeatedly until the character to be entered flashes.
Or, press the button once and press ./>
repeatedly.
To select symbols, press . repeatedly while “A”
is flashing.
2 Press M.
The flashing character is entered and lights
continuously and the cursor shifts to the right.
If you’ve selected numbers
Press the corresponding number button.
The number is entered and the cursor shifts to the
right.
D
4 Repeat steps 2 and 3 to enter the rest of the name.
To enter a space
Press M while the cursor is flashing. Note that you
can’t enter a space for the first character of the name.
To change a character
Press m/M repeatedly until the character to be
changed flashes, press CLEAR to erase the character,
then repeat steps 2 and 3.
5 Press YES.
The whole name appears, followed by “Complete!!,”
and the name is entered.
To cancel the operation
Press MENU/NO or x.
z
You can undo the naming of a track or MD
For details, see “Undoing the Last Edit” on page 34.
z
You can name tracks or MDs using Edit Menu Z
1 Press MENU/NO while the deck is in one of the operating
statuses listed below, depending on what you want to name:
To name Press while the deck is
A track or an MD Stopped, playing, or paused
The track being recorded Recording the track
2 Press ./> repeatedly until “Name ?” appears, then press
YES.
3 Press ./> repeatedly until “Nm In?” appears, then press
YES.
4 Press ./> repeatedly until the track number (when
naming a track) or “Disc” (when naming the MD) flashes, then
press YES.
5 Do steps 2 to 5 on “
Naming a track or MD” above.
Letter/
number
buttons