Filter
Top Products
69
Basic functions
If you want the arpeggio to start at the moment
that recording begins, turn off ARPEGGIATOR
[ON/OFF], hold down a chord on the keyboard,
and then start recording. The arpeggiator will start
at the moment that recording begins, and the
arpeggio will be recorded.
When you record to the end of the pattern, you will
return to the beginning of the pattern and continue
recording.
The musical data that is recorded will be added to
the previously-recorded data.
9 During pattern recording, you can erase unwanted
musical data by pressing the [REC/WRITE] key, or
by checking the “Remove Data” check box.
For details refer to “Loop All Tracks,” step 6
(
☞p.66).
0 Press the [START/STOP] key.
Pattern recording will end.
To use a user pattern that was recorded in this way
(or a preset pattern), you can execute “Put to Track”
to assign the pattern to a track (
☞p.70 in the Parame-
ter Guide).
A pattern can also be used in the RPPR Setup tab
(
☞p.73). (☞p.71 in the Parameter Guide)
In the LCD screen, “USED IN SONG TRACK” indi-
cates how that pattern is assigned to the tracks.
“USED IN RPPR” indicates how that pattern is used
in RPPR Setup (i.e., the keys and tracks to which the
pattern is assigned).
Although you may operate controllers etc. to
record control data in a pattern, you should restore
the control data to its normal value within the pat-
tern. If you fail to restore the normal value, unnec-
essary control data may remain in a “stuck”
position when you place the pattern in a song or
use the RPPR function to play the pattern. How-
ever, the following control data will be automati-
cally reset to the following values when the song
or RPPR function finishes playing the pattern, or
when playback is halted.
Step recording on a track or pattern
To step record on a track, use the P5: Track Edit “Track
Edit” tab page menu command “Step Recording.” To
step record on a pattern, use the P6: Pattern/RPPR
“Pattern Edit” tab page menu command “Step Record-
ing.”
For details on step recording on a track or pattern, refer
to p.61, 69 in the Parameter Guide.
Controller Reset value
Modulation 1 (CC#01) 00 (zero)
Modulation 2 (CC#02) 00 (zero)
Expression (CC#11) 127 (max)
Ribbon controller (CC#16) 64 (center)
Damper switch (CC#64) 00 (zero)
Sostenuto switch (CC#66) 00 (zero)
Soft switch (CC#67) 00 (zero)
EG sustain level (CC#70) 64 (center)
Resonance level (CC#71) 64 (center)
EG release time (CC#72) 64 (center)
EG attack time (CC#73) 64 (center)
Low pass filter cutoff (CC#74) 64 (center)
EG decay level (CC#75) 64 (center)
LFO1 speed (CC#76) 64 (center)
LFO1 depth (pitch) (CC#77) 64 (center)
LFO1 delay (CC#78) 64 (center)
Filter EG intensity (CC#79) 64 (center)
SW1 modulation (CC#80) 00 (zero)
SW1 modulation (CC#81) 00 (zero)
Channel after touch 00 (zero)
Pitch bender 00 (zero)
Sequencer mode