Filter
Top Products
16
Play mode and output the sound from the OUTPUT
jacks, connect a mic or an external audio source to the
AUDIO INPUT 1 and 2 jacks.
● For details on connections when sampling in Sam-
pling mode (
☞p.78).
● For details on connections when outputting from
the OUTPUT jacks in other modes (
☞p.109).
Foot pedal connections
A foot pedal controls etc.
Connect a separately sold Korg assignable pedal such
as the XVP-10 or EXP-2 to the rear panel ASSIGN-
ABLE PEDAL jack.
The function controlled by the foot pedal is specified in
Global: P2 “Foot Pedal Assign” (
☞p.125). (☞p121, 220
in the Parameter Guide)
Foot switch connections
A foot switch controls sostenuto, soft pedal on/off,
arpeggiator on/off, to select programs or combina-
tions, and to start/stop the sequencer etc.
Connect a separately sold Korg foot switch such as the
PS-1 to the rear panel ASSIGNABLE SWITCH jack.
The function that will be controlled by the foot switch
and the polarity of the foot switch can be set in Global:
P2 “Foot Switch Assign,” and “Foot Switch Polarity”
(
☞p.125). (☞p.121, 219 in the Parameter Guide)
Damper pedal connections
A damper pedal applies a damper effect as you play.
Connect a separately sold Korg DS-1H damper pedal
to the DAMPER jack of the TRITON. If a DS-1H is con-
nected, half-damper effects can be produced.
The polarity of the pedal is set in Global P1 “Damper
Pedal Polarity” and the sensitivity is set in Global P1
“Half Damper Calibration.” (
☞p.115, 121 in the Parame-
ter Guide)
The keyboard, controllers and sequencer of the TRI-
TON control and play an external MIDI tone generator,
and an external MIDI keyboard or sequencer plays the
TRITON’s tone generator.
● Use MIDI cables to connect the MIDI connectors
of the TRITON to the MIDI connectors of your
external MIDI device (
☞p.111).
An IBM PC (compatible) or Apple Macintosh com-
puter can be connected to the TRITON, so that the TRI-
TON’s keyboard, controllers and sequencer can
transmit data to the computer, and so that the com-
puter can play the TRITON’s tone generator.
● Connect the TRITON’s TO HOST connector to the
appropriate port of your computer (
☞p.112).
If the separately sold EXB-SCSI option is installed, you
can connect the TRITON to a SCSI-compatible device
(hard disk drive, CD-ROM drive, etc.).
For the EXB-SCSI installation refer to p.237 in the
Parameter Guide.
4. Connecting pedals etc.
5. Connections to MIDI equip-
ment
6. Connections to a computer
7. Connections to a SCSI device