Filter
Top Products
17
Quick Start
Quick Start
Turning the power on/off
Before you turn on the power, make sure that the
desired connections have been made as described
in “Connections” (
☞p.15).
1 Press the TRITON’s [POWER] switch to turn on
the power.
The LCD screen will display the name of your
model (TRITON, TRITON pro, or TRITON proX),
and the software version.
(The following graphic shows the factory-set LCD
screen of the TRITON. The version number is sub-
ject to change without notice.)
2 Turn on your powered monitors or stereo amp.
3 Raise the TRITON’s [VOLUME] slider to an
appropriate level, and adjust the volume of your
powered monitors or stereo amp.
1 Set the TRITON’s [VOLUME] slider and the vol-
ume of your powered monitor or stereo amp to
zero.
2 Turn off the power of your powered monitor or
stereo amp.
3 Press the TRITON’s [POWER] switch to turn off
the power.
The mode and page that will be selected when the
power is turned on
The state of the TRITON when the power is turned on
will depend on the setting of “Power On Mode” (Glo-
bal P0: System Preference tab).
If “Power On Mode” is Reset (factory setting), the TRI-
TON will automatically selects the Combination mode
P0: Play.
If “Power On Mode” is Memorize, the TRITON will be
in the mode and page that were last selected when the
power was turned off.
The Memorize setting will remember the mode and
page that were last selected, the combination number
that was last selected in Combination mode, and the
program number that was last selected in Program
mode.
If another mode is selected when the power is turned
on, you can press the [COMBI] key or [PROG] key to
select the P0: Play page with the last-selected combina-
tion number or program number.
The LCD screen when separately sold options or
SIMM modules are installed
The TRITON series allows you to install separately
sold options or SIMM (sampling memory) boards.
When the power is turned on, the
type of installed options will be
displayed. After installing an
option, be sure to check this dis-
play to verify that the option was
installed correctly. If the option is
not displayed here even though it was installed, it was
not installed correctly. Turn off the power and re-install
the option. (
☞For details on installing an option, refer
to p.237 in the Parameter Guide)
EXB-MOSS: The EXB-MOSS option is installed.
EXB-SCSI: The EXB-SCSI option is installed.
EXB-PCM Slot1 (
****
): A PCM expansion board is
installed in EXB-PCM series slot 1. The type of board is
shown in parentheses.
EXB-PCM Slot2 (
****
): A PCM expansion board is
installed in EXB-PCM series slot 2. The type of board is
shown in parentheses.
SIMM Slot1 (
**
MB): A SIMM is installed in SIMM slot
1. The capacity of the SIMM is shown in parentheses.
When the TRITON is shipped from the factory, a 16 MB
SIMM is already installed in this slot.
SIMM Slot2 (
**
MB): A SIMM is installed in SIMM slot
2. The capacity of the SIMM is shown in parentheses.
1. Turning the power on
2. Turning the power off
Turning the power on/off