Filter
Top Products
98
Using the Remote Controller with Other Components—Continued
Assigning Remote Controller Modes
With this function you can assign a remote controller
mode to an input source. This is useful when you con-
nect, say, a CD recorder to the TAPE IN/OUT sockets.
By assigning the CDR remote controller mode to the
TAPE input source, you can use the remote controller to
control the CD recorder.
You can reset the remote controller to its default set-
tings.
4
Roll the scroll wheel to select the
mode you want to delete, and then
press the scroll wheel.
If the mode is deleted successfully, after
“OK” has been displayed, the DEL dis-
play (step 3) reappears.
1
Press and hold the Custom button
for more than three seconds.
The remote controller enters Custom
mode.
2
Roll the scroll wheel to select
“MODE,” and then press the scroll
wheel.
3
Roll the scroll wheel to select
“ASSGN,” and then press the
scroll wheel.
4
Roll the scroll wheel to select an
input source, and then press the
scroll wheel.
Custom
5
Roll the scroll wheel to select the
mode you want to assign to the
specified input source, and then
press the scroll wheel.
If the assignment is successful, after
“OK” has been displayed, the ASSGN
display (step 3) reappears.
Resetting the Remote Controller
1
Press and hold the Custom button
for more than three seconds.
The remote controller enters Custom
mode.
2
Roll the scroll wheel to select
“MODE,” and then press the scroll
wheel.
3
Roll the scroll wheel to select
“RESET,” and then press the scroll
wheel.
4
Roll the scroll wheel to select
“YES,” and then press the scroll
wheel.
The remote controller is reset to its
default settings.
Custom