Filter
Top Products
65
Enjoying Analog Multichannel Audio Playback—Continued
Before enjoying analog multichannel audio, make sure
that the connections and settings shown on the previous
page are completed.
The illustrations used here represent the remote control-
ler. When you perform the procedures on the DTR-7.4,
use the corresponding buttons on the front panel.
Adjusting the output level of each speaker as desired
Using the remote controller:
Note:
The speaker level for each multichannel analog input is
independent from the speaker level settings made with
the test tone. Therefore, you should perform the proce-
dures above before enjoying analog multichannel audio.
Changing the listening mode
Using the tone control
To disable the tone control function:
Press the Direct/Pure Audio button on the front panel (or
the Direct button on the remote controller).
Playing Analog Multichannel Audio
1
Press the Input button, and then
roll the scroll wheel to select
“DVD.”
2
Press the scroll wheel, and then
press the Audio SEL button
repeatedly to select “Multich.”
On the DTR-7.4, use the Audio
Selector button.
3
Turn on the connected component
and start playing the desired media.
4
Adjust the volume with the Master
Volume dial (or the VOL but-
tons on the remote controller).
1
Press the scroll wheel.
2
Press the CH SEL button and
select the desired speaker.
3
Press the Level – or + button to
adjust the volume level.
Adjust the volume at each speaker so that
all the volumes sound at the same level at
the listening position. For the front right,
front left, center, surround right, sur-
round left, surround back right, and sur-
round back left speakers, the output
levels can be adjusted between –12 and
+12 decibels. The subwoofer can be
adjusted between –30 and +12 decibels.
Input
Audio SEL
VOL
CH SEL
Level
+
Level
-
Each time you press the Direct/
Pure Audio button on the front
panel, the display changes
between “Direct” “Pure
Audio.” When using the remote
controller, press Pure A or Direct.
1
Press the Surround button on the
front panel or the remote control-
ler to display “Tone On.”
2
Adjust the bass and treble sounds.
Select “Setup Menu” → “Audio Adjust
Menu” → “Tone Control” to display the
“Tone Control” sub-menu and perform
the bass and treble settings. For details,
see page 54.
Pure A Direct
Surround
DTR-7.4
Remote
controller
Surround
Making Full Use of Your DTR-7.4