Filter
Top Products
Chapter 8 117
802.16 OFDMA Measurement Application
Measurement Specifications
Description Specifications Supplemental Information
Spectrum Emission Mask
Dynamic Range, relative
5.05 MHz offset 10 MHz BW
a
b
a. The dynamic range specification is the ratio of the channel power to the power in the offset specified.
The dynamic range depends on the measurement settings, such as peak power or integrated power.
Dynamic range specifications are based on default measurement settings, with detector set to average,
and depend on the mixer level. Default measurement settings include 100 kHz RBW.
b. This dynamic range specification applies for the optimum mixer level, which is about −16 dBm. Mixer
level is defined to be the average input power minus the input attenuation.
72.3 dB 78.8 dB (typical)
Sensitivity, absolute
5.05 MHz offset 10 MHz BW
c
c. The sensitivity is specified with 0 dB input attenuation. It represents the noise limitations of the ana-
lyzer. It is tested without an input signal. The sensitivity at this offset is specified with 100 kHz RBW,
at a center frequency of 2 GHz.
−89.5 dBm −95.5 dBm (typical)
Accuracy
5.05 MHz offset 10 MHz BW
Relative
d
d. The relative accuracy is a measure of the ratio of the power at the offset to the main channel power. It
applies for spectrum emission levels in the offsets that are well above the dynamic range limitation.
±0.11 dB
Absolute
e
e. The absolute accuracy of SEM measurement is the same as the absolute accuracy of the spectrum ana-
lyzer. The numbers shown are for 0 − 3.6 GHz, with attenuation set to 10 dB.
20 to 30 °C ±1.05 dB ±0.31 dB (95% confidence)